Quick inventor question

Could you post your code? It is hard to debug that which you cannot see... - Dusk Star [more]

		Chief Delphi > Technical > CAD > Inventor
Quick inventor question

Thread Tools

Rate Thread

Display Modes

30-01-2004, 22:12

ryan_f

Registered User

#1053

Join Date: Jan 2003

Location: ottawa

Posts: 71

ryan_f is an unknown quantity at this point

Quick inventor question

i don't really know a lot of inventor yet but when i get the dimensions in an idw drawing, it only shows the dimensions to 2 decimal places. is there any way to change that?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Q&A Discuss: Quick C Programming Q	CD47-Bot	Extra Discussion	6	16-11-2003 11:16
A quick and entertaining lesson	Veselin Kolev	Chit-Chat	12	19-08-2003 12:28
Quick question about the ramp	archiver	2001	5	23-06-2002 22:45
Quick, need help with two indefinite integrals!	WakeZero	General Forum	2	20-05-2002 14:17
Quick Question, i guess	Andrew Rudolph	Motors	1	12-08-2001 14:39

All times are GMT -5. The time now is 12:40.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.