|
|
|
 Win, Lose or Tie, but do it in a way that FIRSTers will be talking about for years to come! - Bill Moore [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Win, Lose or Tie, but do it in a way that FIRSTers will be talking about for years to come! - Bill Moore [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Radio Cable Burning!!!
OK, Im really confused our team has burned up 3 radio cables. The cables that run from the robot controller to the radio sender/reciever box. We dont have the wire coiled up or anything.....but after about 5min of running the wires burn and short each other out. It also burns the outside plastic that covers all the wires. It actualy makes the outer plastic burn and blister....and somtimes its very hot to the touch. So what might be going on......we dont coil the wires, or run them parallel to other wires!!!!! Any help?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fun Times at the Hardware Store | sanddrag | General Forum | 10 | 19-03-2004 23:55 |
| need 2003 radio/help with old radio | MaxM | Technical Discussion | 2 | 04-01-2004 15:31 |
| LEGO IR tower cable | Jeff Rodriguez | Chit-Chat | 1 | 31-10-2003 16:23 |
| Competition port cable | Ken Leung | Electrical | 2 | 17-09-2003 08:12 |
| PWM and burning out motors | patrickrd | Technical Discussion | 7 | 19-06-2003 15:30 |
Threaded Mode