|
|
|
 I don't mind being odd...I like to - listen - to Dean Kamen's speeches.
They make sense. I don't get to listen to a lot of sense in the world, just a lot of noise. - JaneYoung [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
I-cylinder body wrong?
I was working on our team's inventor award submission. I was working on our goal grabber when I did a constraint that was right, but it was acting wrong. I enventually looked at the actual cylinder (3" stroke, 3/4 inch bore) and it was actually 6 inches. Just to do a sanity check, I made a new one in a new assembly, and it still didn't work. Does anybody else have this problem? Is there a typo on the table (I went through and didn't notice any). Any help would be appreciated.
Thanks, Daniel |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mulit-postioning with pnuematics this year? | KenWittlief | Pneumatics | 101 | 01-02-2005 21:54 |
| Making a series of spaced holes around a cylinder in inventor | James114 | Inventor | 13 | 21-11-2004 18:44 |
| Aspartame | shyra1353 | Chit-Chat | 8 | 20-01-2004 22:41 |
| Is 'using a smaller cylinder' really that easy?? | mjt902 | Pneumatics | 4 | 29-01-2003 16:13 |
| Stopping a Piston... | Dan 550 | Technical Discussion | 7 | 02-02-2002 11:36 |
Linear Mode
