Center goal hardware specs

there is no such thing as too many parts or useless parts, only parts you dont need yet. - Cuog [more]

		Chief Delphi > Technical > Technical Discussion
Center goal hardware specs

View First Unread

Thread Tools

Rate Thread

Display Modes

13-01-2005, 03:26

CSWilken

Registered User

#0634

Join Date: Jan 2005

Location: Van Nuys, CA

Posts: 2

CSWilken is an unknown quantity at this point

Center goal hardware specs

Where can you get the hole pattern specs for the hardware involved in the center goal assembly. Like these:
bottom coupler
mid coupler
pipe nut

thanks

Mr Wilken

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Two vision tetra on center goal?	Guido470	Rules/Strategy	8	09-01-2005 17:50
FIRST and Success: A Question of Definition	Madison	General Forum	70	27-11-2002 08:42
Curie Division Robots information... (not complete)	archiver	2001	3	24-06-2002 03:13
Full list of teams & competitions	archiver	2001	14	24-06-2002 00:52
KSC Results	archiver	2000	2	23-06-2002 22:19

All times are GMT -5. The time now is 06:02.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.