|
|
|
 The fact that although many of us disagree on specifics of how FIRST should conduct events, design a game, and facilitate as much fairness between teams as possible, in the end we still greatly enjoy each other's passion for FIRST and provide genuine respect for each other
- Andy Baker [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Sliding door motor shaft support
Have you ran the sliding door motor with or without support for the shaft in the past? If so, approximately how much tension was on it (or just tell me the size of the sprocket and I can figure it out). Thanks.
|
|
#2
14-01-2005, 18:30
|
|||||
|
|||||
|
Re: Sliding door motor shaft support
We ran it supported only by one side in 2003. I believe we had a 3" drum that we attached to the shaft to wind a cable around
|
|
#3
14-01-2005, 18:37
|
||||
|
||||
|
Re: Sliding door motor shaft support
supported on one side meaning no supports in addition to the motor gearbox itself?
|
|
#4
14-01-2005, 18:39
|
|||||
|
|||||
|
Re: Sliding door motor shaft support
Quote:
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Globe motor, Sliding Door | Coachmac | Motors | 3 | 12-01-2005 14:11 |
| We Need Your SupporT! | coreyk | FIRST Interactive Rural SupporT | 0 | 17-12-2004 21:21 |
| teacher support during robotics | AlbertW | General Forum | 15 | 07-04-2003 19:23 |
| support | Tyler Olds | 3D Animation and Competition | 2 | 07-02-2002 16:32 |
Linear Mode
