|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
Camera DB9 / Calibration Port
Ok, i may be wrong, but if i am not mistaking according to the document about the camera, you can make your own "custom cable" to go to the DB9 port on the camera board. By hooking three wires to the specified pins (shown on the diagram below) and then of course hooking the apporpriote DB9 connector on the other end, i should be able to plug that into the computer and calibrate it that way...........without the hasle of taking over the cover off the camera box every time. Does that sound right?? Or does the calibration program require the use of more pins??
Sorry if you need me to explain more i can try......i am not good at explaining things........i am much better at showing someone what i mean. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Scripting Setup and the Camera + Serial Port Drivers | CJO | Programming | 22 | 11-01-2006 17:42 |
| Kevin Watson's Kick-off Demo Code! | Mr. Lim | Programming | 27 | 22-01-2005 03:38 |
| Game Field Camera Calibration | Matthew_H | Regional Competitions | 2 | 15-01-2005 23:09 |
| CMUCam2 Camera Code - Are important parts commented out? | Mr. Lim | Programming | 4 | 14-01-2005 12:11 |
| New Serial Port Driver | Kevin Watson | Programming | 16 | 09-01-2005 01:56 |