|
|
|
 Look around. What else could cause folks to go sleepless for six straight weeks? That's life-changing, isn't it? :D - Billfred [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Look around. What else could cause folks to go sleepless for six straight weeks? That's life-changing, isn't it? :D - Billfred [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Victors, Default code, & joystick configuration
Here's the deal,
Our team is considering using a two-joystick configuration for the drive-trains, where one joystick controls the right transmission, and the other controls the left. However, one of our electronics mentors says that, due to the default code for the robot, we would end up using all 4 Victors just for the drive-trains. My question is, what exactly is it about the default code that does this, and where among the first documents does it explicitly say that? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| user code to default code | phoenixomega001 | Programming | 5 | 09-01-2005 00:09 |
| heres the code. y this not working | omega | Programming | 16 | 31-03-2004 15:18 |
| Changing 1 joystick code to 2 (rookie team) | Brawler006 | Programming | 5 | 20-02-2004 17:00 |
| EDU Default Code for 1 Joystick | RedNebula | Programming | 3 | 18-12-2003 20:14 |
| robot goes haywire with the one joystick default code | Miles | Programming | 7 | 24-01-2003 14:58 |
Threaded Mode