|
|
|
 I'm intrigued by the possibility of Mayan stadium sports, minus the whole sacrificing part. - AlecMataloni [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I'm intrigued by the possibility of Mayan stadium sports, minus the whole sacrificing part. - AlecMataloni [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Camera Servo
In my custom code, I have three positions I set the pan and tilts to. None of them are the 127,127 position, but wheneverI change them, they immediately move back to 127,127. Is there code in other parts that set the servos to 127,127 after initializing or anything? Thanks.
Edit: Also, is there a way to use the camera_set_servo command and not have to do camera_init again? Everytime, after I initialize the camera and tell it to go to a specific servo position, I don't get any camera feedback. And if I try to initialize again, it goes back to 127,127. Thanks. Last edited by Obi : 29-01-2005 at 13:40. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Scripting Setup and the Camera + Serial Port Drivers | CJO | Programming | 22 | 11-01-2006 17:42 |
| Have you gotten your robot to go towards the vision tetra? | Bharat Nain | Programming | 20 | 25-02-2005 20:18 |
| Unresponsive camera | neilsonster | Programming | 9 | 17-02-2005 08:51 |
| Camera Range Finding | russell | Programming | 9 | 31-01-2005 19:54 |
| CMUCam2 Camera Code - Are important parts commented out? | Mr. Lim | Programming | 4 | 14-01-2005 12:11 |
Threaded Mode