|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
_USE_CMU_CAMERA
Our team is build of rookie programmers. We looked but couldn't find the statement that decides whether or not the #if _USE_CMU_CAMERA is done or not. We are using the FrcCode2005v2.4 default code. If someone could point that out and explain it that would be great.
Thanks in advance |
|
#2
|
|||
|
|||
|
Re: _USE_CMU_CAMERA
Good morning!
I have no idea how rookie you are, so here's a general picture of the situation. When the compiler compiles, you can give it flags that satisfy these #if statements. To see if it is set, go to [project]->[build options]->[build all]. Take this with a grain of salt; I don't have the compiler in front of me, so I could be somewhat off base. There will be a box with a list of flags in similar format, including that one; if I recall correctly, there are normally two. Even if you can't find it, the default code and workspace should have it already set. Best of luck to you! --Jonathan Kunkee, Team 1288 Highest Rookie Seed Award, 2004 |
|
#3
|
|||||
|
|||||
|
Re: _USE_CMU_CAMERA
Quote:
|
|
#4
|
|||||
|
|||||
|
Re: _USE_CMU_CAMERA
Quote:
then the MPLAB C18 tab and you will see the attached. If you want to disable that section of code, then under "Macro Definitions" click on _USE_CMU_CAMERA to highlight it, then click on "Remove." When you want to include the code again, simply click on "Add..." and type in _USE_CMU_CAMERA Last edited by Mark McLeod : 31-01-2005 at 10:33. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|