|
|
|
 If I was making this I would want to not have to use anything smaller than a 3/16" end mill, but 1/8" would be acceptable. Anything smaller and I'd tell the designer to go play in traffic. - Cory [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
04-02-2005, 07:24
|
||||
|
||||
|
gyro/accelecometer/limit switch help needed
Please, people, I need some help.
What is each of the above, what are the uses for them and their limits. Also, I've been looking for a neat way to swithc autonomous startegies on the spot, but I couldn't think of anything more neat than just using digital inputs as they are. If you have the time, please help. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PRESSURE SWITCH | Mr. Steve | Pneumatics | 20 | 01-12-2005 10:20 |
| LEDs in switch box. | ZZII 527 | Electrical | 5 | 06-03-2004 19:39 |
| Digital Inputs interfering with each other | Bongle | Programming | 8 | 23-02-2004 11:18 |
| OI jog switch | Natedude | Control System | 4 | 22-02-2004 17:13 |
Threaded Mode