|
|
|
 Robotics = my anti drug. - Queen_of_Mascot [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Robotics = my anti drug. - Queen_of_Mascot [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
PWM cables: too fragile? what fixes/precautions?
Has anyone else (over the years, or lately) been having problems with PWM cables going/being bad?
I don't think that my team is particularly hard on stuff (especially things that are ~$5 a piece) but each year we seem to run into problems with some the PWM cables working only intermittently, or just not working at all. ...and before I get the warnings... No, We do not do any of the following: * route them beside power wires * do things to/put them in places that would take off insulation * fold/crease the wires * use them as "structural" or "fastening" members, etc... After 5 years of this same problem, I am guessing that this afflicts most other teams as well. What works to counteract this? Any help would be greatly appreciated -Bill |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FYI about using PWM 13-16 with interrupts | cabbagekid2 | Programming | 6 | 22-01-2005 00:54 |
| Using an Operator Interface with the 2004 EDU RC wirelessly | Dave Flowerday | Robotics Education and Curriculum | 34 | 19-04-2004 19:06 |
| In need of PWM Cables! SOON! | Travis Covington | Electrical | 2 | 19-02-2004 20:55 |
| Can we shorten the PWM cables? | RAWdealer59 | Electrical | 3 | 18-02-2003 15:49 |
| Loss of signal in PWM cables. | archiver | 2001 | 6 | 23-06-2002 23:29 |
Threaded Mode