|
|
|
 Difficult? Yeah.
Extremely difficult? Some parts.
Doable? It's been done. - [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Difficult? Yeah.
Extremely difficult? Some parts.
Doable? It's been done. - [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
Measuring a Pulse Width
I'm trying to measure the length of a pulse from a waveform generator to the mini-rc. The signal is a simple square wave; 5 Vp-p, 25 Hz. Unfortunately, I can't seem to get interrupts on the mini-rc to detect any of the edges.
I have the function generator directly connected to the mini-RC. I am verifying the signal on an oscilloscope. Unfortunately, I just can't seem to generate interrupts unless I am removing the PWM cable from the RC. Which makes me believe the software is working at least half correctly. I think it has something to do with the internal pull-up resistor inside the RC. Can anyone shed some light on this? Thanks. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| heres the code. y this not working | omega | Programming | 16 | 31-03-2004 15:18 |
| printf bug - beware! | WizardOfAz | Programming | 8 | 10-03-2004 09:50 |
| SHU measuring stick | sanddrag | Rules/Strategy | 13 | 08-01-2003 21:23 |
| does center barrier have lumber on floor entire width? | archiver | 2001 | 5 | 23-06-2002 22:45 |
| PUlse counting | junkyarddawg | Technical Discussion | 1 | 31-01-2002 15:33 |
Threaded Mode