|
|
|
 This is a solemn reminder of how fast time goes by with the blink of an eye, that if you don't run to catch up with it, it will catch up with you and sweep you away. - Ken Leung [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
[OCCRA]: Motor shaft modification
Can the shaft of the keyang integrated motor be drilled with a small diameter hole to allow a shaft to be pinned directly to it?
|
|
#2
12-10-2005, 21:39
|
||||||
|
||||||
|
Re: [OCCRA]: Motor shaft modification
Quote:
In the past we have allowed the shafts to be coupled and cut if needed. Drilling is also acceptable. Reminder if you damage it beyond use you will need to purchase a new one. We have a limited supply.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OCCRA]: [OCCRA]: Material Donations | xzvrw2 | OCCRA | 2 | 17-09-2005 08:55 |
| [OCCRA]: [OCCRA]: Robot spending limit? | Eric Yahrmatter | OCCRA Q&A | 1 | 13-09-2005 20:31 |
| [OCCRA]: [OCCRA] drill transmission | greencactus3 | OCCRA Q&A | 1 | 11-10-2004 19:31 |
| [OCCRA]: [OCCRA] LEDs | greencactus3 | OCCRA Q&A | 1 | 11-10-2004 19:30 |
| [OCCRA]: motor brush springs | greencactus3 | OCCRA Q&A | 1 | 28-09-2004 20:56 |
Linear Mode
