|
|
|
 Dear Mr. Lavery,
Congratulations. For the fourth year running, you have successfully ruined my Christmas holiday with your untimely release of a most obfuscating, but no less tantalizing, hint. - dubious elise [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
not intersecting parts in inventor
i did find this while searching but im not sure if thats exaclty what i want..
http://www.chiefdelphi.com/forums/sh...n+c onstraint well, im doing a large multipiece project and some parts are ball cups with balls. kinda like a ball and socket... and some of these tend to flip around so the cup wall intersects with the ball end screw.... i dont want this. yes i can manually adjust each and every one so they wont, but every time i have the assembly move, a couple of them spin and stuff so they have intersecting points. is there a way to keep them from doing that? kinda like a motion limit constraint? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FRC 2005 Drivetrain and Transmission Parts on Autodesk Inventor 7 | KrazyRoadster | Inventor | 1 | 23-01-2005 20:29 |
| Changing Dimensions of Virtual parts in Autodesk Inventor 8 | dan963852741 | Inventor | 4 | 19-01-2005 09:41 |
| Rules on making spare parts fyi | DougHogg | General Forum | 0 | 02-04-2003 16:18 |
| Inventor drawings of parts from kit | patrickrd | Inventor | 1 | 11-01-2002 14:16 |
| Inventor and Virtual Kit of Parts | Torchin | Inventor | 1 | 09-01-2002 09:59 |
Threaded Mode