Making the gears drive - motion

17-12-2005, 13:29

ronmarkum

Registered User

FRC #1750

Join Date: Nov 2005

Location: USA

Posts: 8

ronmarkum is an unknown quantity at this point

Making the gears drive - motion

Does anyone know how to set the constraints on spur gears generated in Design accelerator so that when you rotate-move one gear it drives-rotates the other? Using inventor 10 release.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Direct Drive Four Motor System	Collin Fultz	Technical Discussion	42	02-11-2006 12:03
Holonomic Drive Question	Jeff Waegelin	Technical Discussion	12	20-11-2005 21:23
If you could change one thing....	Koko Ed	General Forum	48	31-03-2005 19:23
"Motors and Drive train edition" of Fresh From the Forum	Ken Leung	CD Forum Support	6	29-01-2002 12:32
Gear Making Information	Alan Ing	Technical Discussion	14	29-10-2001 21:08

All times are GMT -5. The time now is 09:34.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.