Big CIM Motor Specifics

13-01-2006, 00:50

jakey

CLOSE THE DEAL

AKA: Jacob

FRC #1717 (DPengineering)

Team Role: Mentor

Join Date: Jan 2006

Rookie Year: 2006

Location: Santa Barbara, CA

Posts: 16

Big CIM Motor Specifics

Hey as a rookie team we were wondering if it is OK to remove the gear tensioner and spring from our CIM motor so all we have left is the motor's shaft? We think we read somewhere that it is OK to do, but cant find it again.

Also...on the Big CIM motor are we allowed to tap our own threaded holes for a custom mount, or should we extend the motor screws in order to mount it...In other words how do we mount the big CIM motor?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
6 CIM Motors?	psquared89	Kit & Additional Hardware	16	09-01-2006 08:47
CIM speed in reverse?	colt527	Motors	41	06-12-2004 19:09
Mercedes-Benz USA Invests in Area Youth	Joe Ross	FIRST In the News...	0	24-03-2004 17:07
CIM vs. Drill motor	duckshepherd	Motors	3	15-02-2003 18:36
Curie Division Robots information... (not complete)	archiver	2001	3	24-06-2002 03:13

All times are GMT -5. The time now is 23:09.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.