|
|
|
 I sure hope kickoff comes soon. Otherwise, you're all getting sent for therapy ;) - Rich Kressly [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I sure hope kickoff comes soon. Otherwise, you're all getting sent for therapy ;) - Rich Kressly [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Labview CMUcam demo problem
Currently, I'm trying to get labview to work with the CMU camera. The camera is powered and our serial plug is plugged in, yet when I set the com to comport4 and press run, it does not run. I am not sure what the problem could be. I am not sure what the program demo itself is supposed to do, but I get an error stating there was a problem connecting. The error states that the error could be because of lack of power or a serial connection problem.
But I am pretty sure there is power and it is connected properly. FYI, we are using a USB to serial converter, which works with the robot controller. Any advice? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| National Instruments LabVIEW and Data Acquisition Forum | Danny Diaz | National Instruments LabVIEW and Data Acquisition | 1 | 16-01-2006 13:20 |
| LabVIEW - CMUcam finds target but cant track | bear24rw | Programming | 6 | 13-01-2006 21:43 |
| Problem installing Labview | Joohoo | LabView and Data Acquisition | 3 | 08-01-2006 10:51 |
| Victor problem | Andy Baker | Electrical | 15 | 24-06-2003 09:49 |
Threaded Mode