|
|
|
 Oh, you know us...kicking puppies and stealing candy from babies and all. :rolleyes: - Travis Hoffman [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Oh, you know us...kicking puppies and stealing candy from babies and all. :rolleyes: - Travis Hoffman [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
gear tooth sensor connecting problem
we have a Little problem
we don't know how to connect the gear tooth sensor we read that have +12V connecting and we don't know were it gone pleas show us were to connect it thank you nirty |
|
#2
23-01-2006, 08:59
|
|||
|
|||
|
Re: gear tooth sensor connecting problem
The 12 needs to be connected to a 20 amp breaker on a fuse panel. This is considered a custom circuit in the electrical rules. Hope this clears it up for you.
|
|
#3
23-01-2006, 12:17
|
|||||
|
|||||
|
Re: gear tooth sensor connecting problem
This has been discussed in this thread.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gear Tooth Sensor | AMIRAM | Electrical | 2 | 22-01-2006 04:09 |
| gears....? | archiver | 2000 | 16 | 23-06-2002 22:58 |
| Major problem with chipphua motors | aka Scott White | Motors | 18 | 19-03-2002 19:44 |
| "Motors and Drive train edition" of Fresh From the Forum | Ken Leung | CD Forum Support | 6 | 29-01-2002 12:32 |
| simple engineering question | Ben Mitchell | Technical Discussion | 2 | 07-11-2001 07:50 |
Linear Mode
