|
|
|
 Duct tape is like the Force - it has a dark side and a light side and it holds the universe together. - Jnadke [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Duct tape is like the Force - it has a dark side and a light side and it holds the universe together. - Jnadke [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Labview keeps freezing
After taking a couple of pictures, the progress bar keeps running over and over again, but the new picture will not load and the buttons lock up. If we restart labview or restart the computer we can take a couple more pictures, but then it locks up again. Turning the camera off and on doesn't seem to help. There was no problem with the installation. We are not getting any of the errors that have been posted in the forum. The TTL adaptor is connected to the camera by a PWM cable but it is not attached to the RC. We configured the com port to the specifications in the camera manual. Does anyone know what we might have done wrong?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Example LabVIEW Apps - Dashboard, CMUcam2 and Motors | Russ Beavis | National Instruments LabVIEW and Data Acquisition | 9 | 21-01-2007 17:19 |
| LabVIEW Com Port Error | 354.FIRST | LabView and Data Acquisition | 4 | 18-01-2006 18:43 |
| National Instruments LabVIEW and Data Acquisition Forum | Danny Diaz | National Instruments LabVIEW and Data Acquisition | 1 | 16-01-2006 13:20 |
| COM port settings for CMUcam labview testing and programming | pwilczynski | Programming | 1 | 15-01-2006 15:09 |
| National Instruments LabVIEW & Data Aquisition Forums | Brandon Martus | Announcements | 0 | 22-11-2005 21:12 |
Threaded Mode