|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
- Made the cam mount assembly
- Attached the cam to robot - Cam works fine - I load kevin's default code into the Controller - In I/O window i get "CR" (What does that mean?) It keeps repeating "CR" - Once i press reset button onto the robot in I/O window i see "RM" (what does that mean?) How i set the cam up ************************************************** ******** - I connected my pan to pwm01 - connected my tilt to pwm02 - I give power to my cam throught pwm03 - Connected my TTL (Mini chip) on to the controller where it says TTL Questions ************************************************** ******** 1) What should my next step be to make my camera work? 2) When i get the values for Red, Green and Blue through GUI? How can i turn it so i can put this colour value into my code? and where and how can i put this colour value into my code? Thank You Very Much ![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| When to leave that first tech job? | Morenoh149 | Career | 4 | 07-10-2005 00:40 |
| QUESTION OF THE WEEK!!! | archiver | 2000 | 14 | 24-06-2002 00:22 |
| Who knows how the motors [I]really[/I] work? | Wetzel | Chit-Chat | 5 | 13-02-2002 21:50 |