|
|
|
 The minibot horse is dead. Stop trying to beat it. Glue is too cheap. - Taylor [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The minibot horse is dead. Stop trying to beat it. Glue is too cheap. - Taylor [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
flat sheet layout of helix?
Our team is using a helical "trough" to guide balls into the gun loading zone. The sides of the trough are easy to layout but the bottom is difficult to do correctly. We have not found a way in Inventor to construct the flat panel layout of the helix - does anyone know the correct method?
An image of the trough with balls is attached. Note: laying out the helix as concentric circles with a slit works reasonably well but does not fit with our team motto: "Good enough is NOT good enough" Bob Holmstrom - Mentor - Team 1432 Portland, Oregon |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Accelerometer data sheet | Joe Ross | Electrical | 16 | 19-01-2005 12:26 |
| How to cut flat sided holes for Globe and Door motor | Max Lobovsky | Motors | 8 | 13-01-2005 14:09 |
| [OCCRA]: Looking for the field layout | Alex Golec | OCCRA | 3 | 28-09-2004 21:35 |
| Offical Inspection Sheet | Wetzel | General Forum | 3 | 26-02-2004 18:43 |
| Electrical wiring layout sheet | George T | Electrical | 1 | 11-02-2003 18:20 |
Threaded Mode