|
|
|
 I think it will be very hard to find one aspect of FIRST which doesn't inspire us. - Arefin Bari [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I think it will be very hard to find one aspect of FIRST which doesn't inspire us. - Arefin Bari [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Control Problem
We just finished the robot we are using 2 cim motors for each transmission, i conected the first speed controller to pwm 1 and the other to 3 and only one side works i tried many configuration connecting the pwm cables.
the side that doesnt work turns green sometimes on the speed controller. any ideas do i have to load the default coode |
|
#2
08-02-2006, 00:44
|
|||
|
|||
|
Re: Control Problem
If the light goes green but the motor does not try to spin at all, chances are good you either have a loose wire between the controller and motor or have a dead speed controller (blown FET, etc).
|
|
#3
08-02-2006, 01:11
|
|||
|
|||
|
Re: Control Problem
Are you using four Victors or only two?
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Driving control scheme? | ChuNalt787 | General Forum | 29 | 05-02-2006 01:04 |
| Control Theory | DanDon | Programming | 7 | 12-01-2006 13:15 |
| [OCCRA]: Size limit of Operator Control Station | Alex Golec | OCCRA Q&A | 1 | 11-10-2005 05:33 |
| Ok one problem | cantwell03 | Programming | 3 | 13-02-2003 07:28 |
| The problem with scouting... | archiver | 2001 | 10 | 23-06-2002 23:49 |
Hybrid Mode
