|
|
|
 It isnt about winning and losing (although getting the trophies and medals are nice) - Winged Wonder [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It isnt about winning and losing (although getting the trophies and medals are nice) - Winged Wonder [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
HELP!!! Calibrating Victors
We are in dire need of some help regarding the calibration of the victors. We have them attached to one of the CIM motors we will be using in the KIT transmission. We pulled the motor out of the transmission so it doesn't conflict with the other motor.
When we go through the calibration process we get an unsuccessful (red light blinking) calibration each time. We have tried to reset the victors to factory calibration but we have the same problem. We also can't seem to find the dead zone on the joystick. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Blown Victors - WHY? | wmurphy | Control System | 18 | 05-02-2005 18:31 |
| 24Vs and victors | greencactus3 | Control System | 13 | 05-02-2005 14:22 |
| Calibrating Victors | SpaceOsc | Control System | 27 | 19-11-2004 07:59 |
| Flakey Victors | archiver | 1999 | 4 | 23-06-2002 21:58 |
| DON'T Recalibrate Victors! | Joe Johnson | Off-Season Events | 0 | 12-11-2001 22:58 |
Threaded Mode