|
|
|
 This system sucks more than our ball possession system. - IndySam [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| This system sucks more than our ball possession system. - IndySam [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Inventor part needed
Hey all-
I need an Inventor part, preferably as soon as possible. The part I need is usually hosted on FirstCadLibrary, but the site seems to currently down. The part is the I-cylinder. On a second note, if anyone happens to have a Inventor part of a 3/4 inch bore 3 inch stroke pneumatic from bimba, that would also be helpful. You can email me at craigih@pacbell.net, or just PM me to a link of the part. Thanks! |
|
#2
20-03-2006, 21:07
|
|||||
|
|||||
|
Re: Inventor part needed
Quote:
 |
|
#3
21-03-2006, 18:26
|
|||
|
|||
|
Re: Inventor part needed
Thanks a ton.
We ended up using the file which was hidden in the deep scary mass of one of our mentors computer. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help needed for getting started! | chantilly_team | Programming | 4 | 27-10-2004 08:29 |
| Chamionship Qualification - feedback needed ASAP! | dlavery | General Forum | 97 | 11-10-2003 07:17 |
| Weight needed to tilt bridge... | archiver | 2001 | 4 | 23-06-2002 23:43 |
| Battlecry 3 volunteers needed? | Hymnson | Off-Season Events | 4 | 02-06-2002 12:38 |
| Inventor 5.0 help needed | Larry Barello | Inventor | 4 | 27-01-2002 10:54 |
Linear Mode
