|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
I am using EasyC and a VEX Ultrasonic sensor, and the "GetUltrasonic" command hangs up my code for 1/4 - 1/2 second each time it's used (once per loop).
Has anyone else had this happen? Has anyone had this not happen? Has anyone fixed this problem? Has anyone used the Ultrasonic sensor with "hard" C? If your ultrasonic code (Easy or hard) runs smoothly, would you mind sharing it? Thanks Edit: Should this be in the EasyC for FRC section? Sorry about that. Last edited by P1h3r1e3d13 : 23-03-2006 at 18:48. Reason: See below |
|
#2
|
||||
|
||||
|
Re: VEX Ultrasonic Sensor delay
Are you running the current version. The ultrasonic should not hang your code.
Adam |
|
#3
|
||||
|
||||
|
Re: VEX Ultrasonic Sensor delay
Yup - current version of EasyC.
I know it shouldn't hang the code. I'm assuming you mean you have experienced it working properly, and I'll take that as a good sign. I just realized it doesn't seem like I'm even getting data - I have it outputting to the OI display and all it shows is u000 or an occasional u012. It has worked before, though (in a completely different program), so the sensor itself is not broken. |
|
#4
|
|||
|
|||
|
Re: VEX Ultrasonic Sensor delay
Quote:
|
|
#5
|
||||
|
||||
|
Re: VEX Ultrasonic Sensor delay
Thanks.
It may be a week or two now before I get the chance, but I will try that. I appreciate your helpfulness. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vex Ultrasonic Sensor not responding | SomeoneKnows | Programming | 6 | 18-12-2007 16:48 |
| Radio Shack to discontinue VEX? | jeffmorris | General Forum | 52 | 24-03-2006 16:33 |
| Vex navigation with ultrasonic and encoders | GlennGraham | Electrical | 4 | 13-01-2006 12:58 |
| VEX UltraSonic and Encoder SOLD OUT... | Chris_Elston | Electrical | 5 | 09-01-2006 13:22 |
| VEX Robotics | vexrobotics | FIRST Tech Challenge | 8 | 30-03-2005 23:25 |