|
|
|
 The term defensive robot and mechanum wheels do not belong in the same sentence together. - Koko Ed [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| The term defensive robot and mechanum wheels do not belong in the same sentence together. - Koko Ed [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Volume/Weight Calculations in Inventor
This is a problem that has bothered me for some time.
Is there a tool in Inventor 10 that can be used to calculate the volume of a part? I know you can do this in Autodesk VIZ but what about Inventor? It would sure make calculating robot weights a lot easier... Any help/suggestions? Last edited by =Martin=Taylor= : 08-04-2006 at 00:23. |
|
#2
08-04-2006, 00:24
|
|||||
|
|||||
|
Re: Volume/Weight Calculations in Inventor
Quote:
Go to File->iPropeties->Physical, and you can select the material you want to make the part out of, and it'll automatically use the volume and density of said material to give you the mass of the part. If Inventor doesn't have the material you want, you can manually input it's properties, and add it to the list. |
|
#3
08-04-2006, 10:21
|
||||
|
||||
|
Re: Volume/Weight Calculations in Inventor
haha yea our teachers in ddp would always evaluate us based on whether our volume was the same as theirs.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Inventor Help | bjimster1 | Inventor | 9 | 14-01-2006 17:01 |
| **FIRST EMAIL**/Autodesk Software Donation, Inventor Training and Awards Information | Beth Sweet | FIRST E-Mail Blast Archive | 3 | 05-10-2005 23:34 |
| Inventor 201 Whitepaper | petek | Inventor | 0 | 10-05-2005 13:03 |
| Inventor Tetra Connector | team222badbrad | Inventor | 24 | 14-01-2005 10:25 |
| Autodesk Inventor Award 2002 | Digo | Inventor | 1 | 24-03-2002 12:07 |
Linear Mode
