|
|
|
 we can crank up the volume and let the world know that we are nerds with a pulse! - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| we can crank up the volume and let the world know that we are nerds with a pulse! - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
Flexible shafts working with CIMs
Yesterday, while walking through a hobby works, I bought the flexible shaft Dremel attachment. I was really surprised by how amazingly well it works. It can be bent nearly 360 degrees with very little impairment of shaft rotation. Anyways, I realized how this could be really helpful in some of the applications I had in mind. Does anyone know where I could get one that will couple with a CIM?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Working with Gyros | DavidSJohnson | Programming | 1 | 10-02-2006 00:16 |
| Working with Lexan | Phil Paspalas | Technical Discussion | 41 | 09-02-2006 16:14 |
| Building fully flexible tail (several joints) with minimal actuation required | sanddrag | Technical Discussion | 51 | 27-11-2005 18:05 |
| Shorten The Flexible Drive Shafts? | milesdf | Motors | 2 | 08-02-2004 12:27 |
| Working with Potentiometers | GrahamS314 | Programming | 11 | 02-02-2003 14:34 |
Threaded Mode