|
|
|
 If you want to prove your worth, prove it by creation, not destruction. - DanL [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If you want to prove your worth, prove it by creation, not destruction. - DanL [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Programming the vex microcontroller to respond to commands on the serial port
Right now I'm developing a robot to operate with a vex and a pc controlling the vex. How do I get the Vex to respond to the serial port commands? I've found the JVEX reference and that protocol information doesn't work for the online code nor the hex that they provide. Any advice?
|
|
#2
20-10-2006, 14:17
|
|||
|
|||
|
Re: Programming the vex microcontroller to respond to commands on the serial port
So Far I've gotten the robot to initialize and send back the DIN information in online mode
(Note decimal values) Init: 15 15 8 64 184 4 Request DIN: 170 85 0 0 0 11 0 0 |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PIC18F8520 port mapping to VEX microcontroller module. | Yuriy | Programming | 2 | 28-04-2006 13:11 |
| Scripting Setup and the Camera + Serial Port Drivers | CJO | Programming | 22 | 11-01-2006 17:42 |
| Programming Vex Starter Kit To Recieve From Serial Port | firetrap | FIRST Tech Challenge | 0 | 26-09-2005 17:27 |
| Serial Port Programming | phrontist | General Forum | 1 | 07-02-2004 16:13 |
| Communications via the Programming Port | Larry Barello | Technical Discussion | 9 | 10-06-2003 23:33 |
Hybrid Mode
