Question on v-belts - Chief Delphi

19-11-2006, 12:03

Joe_Widen

Registered User

FRC #1675 (The Ultimate Protection Squad)

Team Role: Alumni

Join Date: Jan 2006

Rookie Year: 2005

Location: Milwaukee

Posts: 215

Question on v-belts

Ok, so I'm designing a cvt. I've tried searching everywhere and I can't find the full specs of a vbelt. McMaster only gave me the width at the top and the height. Anyone know how to figure out the width of the bottom, or the angle of the sides of the vbelt?

__________________
Finally in college =]

2009 Midwest Regional Champions - Thanks 111 and 1625

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ordering Belts	=Martin=Taylor=	Technical Discussion	4	19-09-2006 21:32
Belts in Inventor	Hunter Levesque	Inventor	7	22-04-2006 10:11
Conveyor belts	Max Lobovsky	Technical Discussion	4	12-01-2006 19:32
Belts, Timing Belts, and Automobiles.	Anton Abaya	Technical Discussion	5	09-01-2002 19:21
Conveyor Belts	Pengiun Joe	Off-Season Events	2	02-11-2001 22:49

All times are GMT -5. The time now is 17:05.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.