|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Ringer pressure
Is there going to be a set pressure on the ringers at the begining of each match?
If so does any ones know? |
|
#2
|
||||
|
||||
|
Re: Ringer pressure
i looked for that but could not find it in the rules. however they list the dimensions of the rings at 13' inner ring, 32 inches outer ring and 91/2 inches tall. my guess is they will blow them up so they meet are approximately this size.
|
|
#3
|
|||
|
|||
|
Re: Ringer pressure
After Kickoff in Manchester there were people deflating the tubes, I asked them if they knew the details about inflating them. I was told that they just inflated them till they felt full. They also said that the air pumps they used would only inflate them so far, and were not powerfull enough to pop them. No standards just blow them up till they are full.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: 2 ringer spacing | Ryan Foley | Extra Discussion | 3 | 07-01-2007 01:31 |
| pic: Spoiler and Ringer on top leg 2 | Ryan Foley | Extra Discussion | 1 | 07-01-2007 01:25 |
| Pressure Pads | Deltafrog | Rules/Strategy | 6 | 09-01-2005 00:27 |
| Translating pressure sensor readout into actual pressure | Mercutio | Pneumatics | 0 | 13-02-2004 16:29 |
| Pressure Sensors | gthakore | General Forum | 14 | 12-01-2003 19:23 |