|
|
|
 TL;DR: The robot battery (and your car battery) aren't going to electrocute you unless you stab a positive and negative wire from them into your heart. In which case you have plenty of other problems besides. - Kevin Sevcik [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Springs in Inventor
Hey, I tried looking for an answer to this somewhere but wasn't successful please don't flame me if this has been asked previously...
 Anyway I need to model some working springs for an assembly that I'm doing, I'm trying to use the Design accelerator but I don't know a lot of the spec's it's asking for (I know the spring constant (Lbs/in), length, material, wire diameter, and outer diameter). Is there another way to do this? Anyone care to help me? Thank you very much!!!  |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Springs?! | StashZabriski | Technical Discussion | 6 | 25-01-2007 13:59 |
| Springs | Mike Martus | OCCRA | 1 | 23-10-2003 02:28 |
| springs | hi_im_sean | Technical Discussion | 4 | 23-01-2003 19:05 |
| Springs | Jeff Waegelin | OCCRA | 1 | 24-09-2002 05:34 |
| springs | CharlieWilken | Technical Discussion | 3 | 30-01-2002 19:39 |
Threaded Mode