|
|
|
 I'd just give you the URL, but then you wouldn't learn to look for yourself. - DonRotolo [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I'd just give you the URL, but then you wouldn't learn to look for yourself. - DonRotolo [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#2
07-02-2007, 23:17
|
||||
|
||||
|
Re: "Demo Stamp not found" error message
I've never seen this before.
The Basic Stamp II was an IC chip used prior to 2003 in our IFI robot controllers... What program and what controller are you using? |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Congratulations is spelled with a "T" and not a "D"!! | Elgin Clock | Thanks and/or Congrats | 55 | 09-03-2007 13:24 |
| CMUCam2 Demo - File Not Found Error | TechnoDrake | LabView and Data Acquisition | 6 | 12-01-2007 15:56 |
| Persistent "no robot controller found" error | 1594code | Programming | 12 | 20-02-2006 20:59 |
| Screenshot of "code not understood" or similar error needed! | Elgin Clock | Programming | 3 | 17-02-2006 22:06 |
| Program error - "can not fit the section" | miketwalker | Programming | 9 | 20-02-2005 01:21 |
Hybrid Mode
