|
|
|
 Stacking totes on end;
Gives you extra height, alas;
Topples with a sneeze. - BethMo [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Stacking totes on end;
Gives you extra height, alas;
Topples with a sneeze. - BethMo [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#2
22-02-2007, 16:19
|
||||
|
||||
|
Re: help in assembly
You should be able to just put dimensions in the .idw from the assembly. Change to your drawing annotations panel and use the general dimension tool. I could help you better if you were more specific.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Assembly code in C? | red_alert_13 | Programming | 3 | 21-07-2005 15:01 |
| Assembly? | Astronouth7303 | Programming | 2 | 12-08-2004 11:30 |
| Importing assembly into an assembly... | James Green | Inventor | 8 | 22-01-2004 22:17 |
| Assembly Code | Venkatesh | Programming | 1 | 18-11-2003 17:39 |
| Assembly?!? | archiver | 2000 | 2 | 23-06-2002 22:05 |
Linear Mode
