Worm Gear - Chief Delphi

Power tools don't hurt people. Poorly instructed people hurt themselves, using power tools. - sanddrag [more]

		Chief Delphi > Technical > Motors
Worm Gear

Thread Tools

Rate Thread

Display Modes

27-02-2007, 10:51

Calvin_1631 Calvin_1631 is offline

Registered User

AKA: Calvin

FRC #1631 (Cybernetic Cougars)

Team Role: Electrical

Join Date: Jan 2006

Rookie Year: 2005

Location: Las Vegas

Posts: 27

Calvin_1631 is an unknown quantity at this point

Worm Gear

Hello, I am new to gearboxes and everything associated with them. I was wondering if it is possible to take the big 3" CIM motor and make, well essentially, a worm gear to use on a pivot arm, allowing the arm to stay in the position it was rotated to.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Worm Gears	FIRST JerseyKid	Technical Discussion	13	18-01-2006 10:13
worm gear emergency	ClicheCow	Technical Discussion	5	21-02-2005 01:39
Van Door Motor Worm Gear	Anthony	Motors	5	14-02-2005 07:33
Worm Gear Gearbox	dddriveman	Technical Discussion	38	07-01-2005 14:43
Van Door Worm Gear	Jim Giacchi	Motors	4	16-12-2003 09:35

All times are GMT -5. The time now is 23:04.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.