|
|
|
 The FIRST community will always step up in times of need. - nikeairmancurry [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The FIRST community will always step up in times of need. - nikeairmancurry [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||||
|
||||||
|
encoder counting and onscreen feedback *ASAP
Hey,
I am working on a project and need some help. I am using a vex wheel encoder connected to a shaft which I need to see # of revolutions and RPM on my computer. I was thinking I could do this through the real time link with the controller. I really have no idea where to start and I have a signifigant time crunch on this. Also what is the max RPM that the encoder can detect, I am planning on using it at about 450 RPM. Thanks.. P.s. this is for 5:00 tonight (2/27) any help would be appreciated. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems with Encoder Counting | bjimster1 | Programming | 19 | 07-03-2007 09:59 |
| Encoder Counting Problems | RyanW | Programming | 1 | 14-02-2007 15:17 |
| Encoder counting randomly off by x4 factor | jgeorge | Programming | 5 | 02-02-2006 21:17 |
| Problems counting encoder pulses | bludstayne | Programming | 7 | 02-02-2004 23:07 |
| Chamionship Qualification - feedback needed ASAP! | dlavery | General Forum | 97 | 11-10-2003 07:17 |
Threaded Mode