Spur gear to go CIM for 56mm Banebots

30-05-2007, 01:27

John Gutmann John Gutmann is offline

I'm right here

AKA: sparksandtabs

FRC #0340 (GRR)

Team Role: Mechanical

Join Date: Feb 2005

Rookie Year: 2004

Location: rochester

Posts: 804

Send a message via Yahoo to John Gutmann

Spur gear to go CIM for 56mm Banebots

I need to know a few specs of the 56mm gear that goes on the CIM for the banebots transmission they are:

diametric pitch (dp)
# of teeth
pressure angle (pa)
bore size (inside diameter)
length (or face width
material

-John

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
BaneBots 56mm Gearbox - Second Stage Sun Seizing	Gary Bonner	Motors	18	10-02-2007 12:52
New Banebots 56mm transmissions for sale	fsracer	Motors	1	07-02-2007 22:58
pic: 166 CIM Support Bracket on 56mm transmissions	Dan Petrovic	Extra Discussion	5	28-01-2007 18:42
Spur Gear Rod?	David Guzman	Technical Discussion	6	18-01-2006 22:53
Gear Ratio Math for Cim Motor FP801-005	KogaVanDragon	Motors	2	14-01-2006 02:38

All times are GMT -5. The time now is 23:03.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.