|
|
|
 *When putting grease on anything* "The bigger the glob the better the job." - TheMagicPenguin [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| *When putting grease on anything* "The bigger the glob the better the job." - TheMagicPenguin [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Inventor > G-Code - HOW!!??
OK. So, I have a project that needs some pretty fancy cutting. I've never converted anything to G-code before - always just written the code myself from drawings.
My mill control program (Mach 3) can convert .dxf files to g-code fairly easily. But inventor doesn't export .dxf's... I searched the forums and was rather shocked to see that this has never been discussed before. I'd think with all the Inventor users in the FIRST community at least someone would know how to do this. So what's the best way to go about getting a 2-D g-code out of Inventor? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how do i get inventor? | GMKlenklen | Inventor | 6 | 17-11-2006 21:07 |
| how to convert Easy C code into real code? | TheHolyLancer | Programming | 1 | 29-01-2006 09:09 |
| How to Stack Tetras in Inventor | petek | Inventor | 0 | 13-01-2005 11:47 |
| How did you learn how to use Inventor? | Greg McCoy | Inventor | 26 | 24-05-2003 01:55 |
| How do i make gears in inventor? | mnkysp6353 | Inventor | 1 | 16-01-2002 02:31 |
Threaded Mode