|
|
|
 Blue shirts are ALWAYS watching. And they have spies everywhere. Always be on your best behavior, and be polite to every volunteer at the event. - Andrew Schreiber [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Blue shirts are ALWAYS watching. And they have spies everywhere. Always be on your best behavior, and be polite to every volunteer at the event. - Andrew Schreiber [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Using the IR Receiver on the Robot
I've been looking through the forums to find info about incorporating the IR Receiver on the Robot. Here's a list of what I've found so far
IR User Guide and the video from the Kickoff I haven't found much info yet. I was wondering if anybody has found a wiring diagram for the receiver board (listing replacement components) or anything else of general interest. Also I'd like to hear what challenges and successes other teams are facing as they use the IR in test hybrid modes. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using a VEX Receiver with Non-Vex Equipment | akaria | VEX | 26 | 06-09-2008 00:55 |
| Using the Robot Simulation Toolkit to simulate OI Controls | JimGRobot | LabView and Data Acquisition | 1 | 17-03-2007 04:14 |
| Where do I begin to get the robot to move using the camera? | Ianuser | Programming | 10 | 16-02-2007 17:55 |
| Running the robot using Infa Red? | Burg | Robotics Education and Curriculum | 7 | 30-12-2004 12:31 |
| How to connect the R/C receiver?! | Tim Skloss | Robotics Education and Curriculum | 7 | 10-12-2003 16:34 |
Threaded Mode