|
|
|
 changing some 0 to 1s was a lot lighter and cheaper than most of the clutches I found. - IKE [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| changing some 0 to 1s was a lot lighter and cheaper than most of the clutches I found. - IKE [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Toughbox Assembly
Has anyone else had problems assembling the toughbox? I cannot get the large bearing over the large shaft. I tried using force but it barely starts and gets stuck. Any recommendation to getting this piece on. I am afraid if I use to mush force it will get started and I wont be able to get it back off.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Toughbox mounting bracket models | Rob | CAD | 2 | 10-01-2008 11:34 |
| Toughbox Assembly Video on YouTube | Andy Baker | Technical Discussion | 25 | 08-01-2008 15:10 |
| AM Toughbox Model(s) available | Ed Sparks | CAD | 2 | 08-01-2008 11:15 |
| Assembly? | Astronouth7303 | Programming | 2 | 12-08-2004 11:30 |
| Importing assembly into an assembly... | James Green | Inventor | 8 | 22-01-2004 22:17 |
Threaded Mode