|
|
|
 I happen to know that there is a back-order status from Exide. Seems for some reason people are ordering this product - Mike Martus [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I happen to know that there is a back-order status from Exide. Seems for some reason people are ordering this product - Mike Martus [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
Can't mount the gear tooth sensors
The new AndyMark gearboxes are different from the 2006 version and I can't seem to figure out how to make the gear tooth sensors fit.
Using 0.75 inch standoffs I can make the board just fit, but it rubs against the gear--unacceptable. We followed the AndyMark gearbox instructions and the gears look correct, but this year the gear to be sensed is not up against the cover. Did I miss something simple? Thanks in advance. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help with the Kit Gear Tooth sensors | Keo-san | Programming | 9 | 20-02-2007 08:07 |
| dumb question: Where do we get the gear tooth sensors from? | waialua359 | Programming | 6 | 30-01-2007 22:45 |
| where can we buy hall effect sensors or gear tooth sensors | amirjpl | Electrical | 3 | 13-02-2006 11:02 |
| Gear Tooth Sensors | et1337 | Electrical | 7 | 28-01-2006 22:48 |
| Accelerometer vs Gear Tooth Sensors | zdeswarte | Electrical | 4 | 22-01-2005 15:35 |
Threaded Mode