|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Bad Gyro???
ok i have been writing some gyro code for this year. I am not asking about the coding aspect but the electrical. I have just soldered up our 2007 and 2008 gyros and I am not getting any change in voltage when I rotate the chip. I didn't solder up the temperature pins and I cannot find anything that would make it seem neccessary to do so. The thing that bugs me is that I know it isn't my codebecause I have a gyro from way back and it works on the same principle and it is fine.
Has any one found these problems before? and if so was there anything that you did that made the gyro return a valid voltage? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How "bad" are motors with "bad" stickers? | cooknl | Kit & Additional Hardware | 20 | 12-01-2005 10:33 |
| Is it Bad? | JulieB | Chit-Chat | 26 | 18-11-2004 23:48 |
| Bad day!!! | c-squared_2006 | Chit-Chat | 17 | 09-04-2004 14:45 |
| Bad planing | nuggetsyl | General Forum | 1 | 15-11-2002 13:00 |
| Bad, bad, bad!!! | archiver | 2000 | 13 | 23-06-2002 22:29 |