|
|
|
 When I see stuff like that, sometimes I say, "That's BRILLIANT, why didn't I think of that?" But I never like the answer.
- dtengineering [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| When I see stuff like that, sometimes I say, "That's BRILLIANT, why didn't I think of that?" But I never like the answer.
- dtengineering [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
9 pin cable from radio to RC
Do I have to use the supplied cable, or can I make my own shorter more flexible cable out of flat cable?
<R67> ...and 9-pin cables shall not be tampered with, modified, or adjusted in any way. <R71> Ribbon cable ... may be used to connect signal lines to the 9 pin ports on the Robot Controller. The space I have to mount the RC in is kind of funky, and If I have to use the bulky supplied cable, our RC is going to have to be mounted vertically or something... |
|
#2
23-01-2008, 21:03
|
|||||
|
|||||
|
Re: 9 pin cable from radio to RC
You will probably want to check out this Q&A system answer, which addresses how the radio modem must be connected to the RC.
-dave |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Innovation First acquires Vex from Radio Shack | Brandon Martus | General Forum | 58 | 20-04-2006 17:32 |
| VEX Kits for Sale from Radio Shack | fowlerm | FIRST Tech Challenge | 8 | 12-04-2005 14:07 |
| Radio Cable Burning!!! | Cadetdan | Electrical | 10 | 15-02-2004 09:46 |
| Cable Pin outs | Wetzel | Electrical | 8 | 10-01-2004 13:50 |
| using set screw or dowel pin/pin to hold on drill motor coupler thinggy | Travis Covington | Motors | 1 | 04-02-2002 03:02 |
Hybrid Mode
