|
|
|
 The point of FIRST is not to create pretty robots. It's to teach kids about science, technology, and engineering. - Cory [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The point of FIRST is not to create pretty robots. It's to teach kids about science, technology, and engineering. - Cory [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Pressure optimization
We have a 2" x 24" cylinder and a 2" x 12" cylinder which are connected end-to-end. We are using 4 tanks and our compressor. I have looked at some calculations about pressure about how 60spi will create a 95 pound force in a two inch bore. I don't need all of this force and just need about 40 pounds, without sacrificing speed. Is the Festo solenoid more effective than the smc one? Also what would be the ideal pressure?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Automatic Spoiler Optimization | Jared Russell | Rules/Strategy | 1 | 02-02-2007 22:16 |
| general - optimization | hanan | Programming | 2 | 20-01-2007 07:03 |
| Pressure Pads | Deltafrog | Rules/Strategy | 6 | 09-01-2005 00:27 |
| Translating pressure sensor readout into actual pressure | Mercutio | Pneumatics | 0 | 13-02-2004 16:29 |
| pressure switch | Michael Long | Pneumatics | 1 | 11-02-2003 11:21 |
Threaded Mode