Bumper segments - Chief Delphi

05-02-2008, 17:40

diesel

Registered User

FRC #2077

Join Date: Oct 2007

Location: Wisconsin

Posts: 50

Bumper segments

We are helping a new team this year, and I believe we have run into a unique problem with bumpers.

None of the sides of the robot are six inches long (It's a 12 sided 'bot).
And the GDC seem very strict about not putting plywood into the corners.

So how do we build bumpers that are more than six inches long and do not have plywood in the corners. Even if we made two bumpers that each covered half the robot, those bumpers would have plywood in the corners.
How do we overcome the problem?

__________________
Design. Build. Dew.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Bumper Qs	Woody1458	General Forum	13	29-01-2009 16:41
bumper noodles	lopz056	General Forum	3	24-01-2008 21:13
bumper	coolguybigt	Technical Discussion	4	27-02-2007 16:40
Bumper rules	robotraj111	Kit & Additional Hardware	1	19-02-2006 20:36
Bumper or No?	WebWader125	Technical Discussion	19	11-01-2006 01:28

All times are GMT -5. The time now is 05:39.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.