|
|
|
 So, if you feel your team is at a disadvantage, or the playing field isn't level.... Do something about it. - AdamHeard [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| So, if you feel your team is at a disadvantage, or the playing field isn't level.... Do something about it. - AdamHeard [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
DeWalt Transmissions and Globe Motors
Our team just got a hold of a couple DeWalt Transmissions. Following the Nothing But DeWalt white paper by Joe P. we began the assembly. We have run into a problem very quickly in step 3 of the globe motor process. It talks about a "modified pinion gear from the extra transmission (.138 inch +0.0000" -0.0005" hole)". This is meaningless to me and the rest of our team. I have searched the entire white paper and found nothing about a modified pinion gear. Has anyone had this problem? What is a modified pinion gear, and where can I find one?
Thanks for the help. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| More questions about Dewalt transmissions | AJ R | Technical Discussion | 3 | 15-01-2007 17:38 |
| Dewalt transmissions | Gabe | Technical Discussion | 19 | 01-01-2007 01:55 |
| Inventor Files for Dewalt Transmissions! | Dylan Gramlich | General Forum | 2 | 29-12-2006 01:29 |
| Dewalt Transmissions | Joe P | Technical Discussion | 9 | 09-09-2004 21:07 |
| Drill Motors and Transmissions | Mr. Mac | OCCRA | 0 | 06-11-2002 22:30 |
Threaded Mode