|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Our team is using easyC and I was wondering how we start programming the pneumatics. We think we're going to use 3 buttons, one for piston #1, one for piston #2, and one to turn the air compressor on/off. We've finished programming the motor controls so we have a good handle on the code and how it works. If someone could give us some advice to get us started that'd be great.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HUD Integration with EasyC | Tach'ko | Programming | 0 | 29-01-2008 19:36 |
| EDU programming with easyC | SgtMillhouse648 | Programming | 4 | 11-07-2007 15:58 |
| CMUCam with EasyC | gabrielse | Programming | 5 | 01-02-2006 14:28 |
| Shifting with easyC | Erics626 | Programming | 1 | 24-01-2006 18:58 |
| Pumping with pneumatics? | Billfred | Lego Mindstorm Discussion | 7 | 27-05-2004 18:39 |