IRI Bord question

Team2441 · #1 13-02-2008, 20:32

Our team is thinking of putting our IRI board under a plexi glass cover that is protecting the electronics. Will it still be able to receive a signal under the plexi glass?

kevin.li.rit · #2 13-02-2008, 20:35

If It's clear I'm pretty sure it will. One way to find out is to try it!

Team2441 · #3 13-02-2008, 20:41

Thank you very much its better to be safe then sorry

program1 · #4 13-02-2008, 20:50

ok i don't want to make a new thread for a question about the IR also,

where is the best place to put the IR board?

kevin.li.rit · #5 13-02-2008, 20:53

That depends on your robot design... You should put it somewhere visible so you can use the remote and also somewhere safe from impact. We're probably going to mount it on a servo and stick it in the front with some polycarb around it to protect it.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ASAP IRI Question--!!	litchi_chan	Off-Season Events	2	01-08-2007 21:04
IRI Travel Arragements (Airport -> IRI -> Airport)	BandChick	Off-Season Events	14	18-07-2007 15:30
IRI	Molten	General Forum	7	02-04-2007 16:45
IRI Travel arrangements (airport to IRI & IRI to airport)	Elgin Clock	Off-Season Events	25	19-07-2006 11:04
FF IRI 2.0	Ian Curtis	Fantasy FIRST	80	24-07-2005 20:11