|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
pressure switch
we lost the pressure switch to our pressure gauge
is the switch necessary? do you really need it? |
|
#2
|
|||||
|
|||||
|
Re: pressure switch
The pneumatic system has several required parts and the pressure switch connected to the RC is one of those parts. You must show that the compressor is under control of the RC and using the presure switch to turn off the compressor. You also need a regulator and at least two guages to show high side (~125 PSI) and low side (60 PSI or below) pressures. The compressor needs to be controlled through a Spike relay and the fuse in that relay only may be replaced by a 20 amp auto resetting circuit breaker. Full pneumatic rules are contained the Section 8 The Robot.
|
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wiring pressure switch | m1k3 | Electrical | 13 | 11-01-2008 12:44 |
| PRESSURE SWITCH | Mr. Steve | Pneumatics | 20 | 01-12-2005 10:20 |
| pressure switch | Michael Long | Pneumatics | 1 | 11-02-2003 11:21 |
| pressure switch | Antonio | Pneumatics | 10 | 31-01-2003 03:52 |
| pressure switch | piconysm | Technical Discussion | 5 | 14-02-2002 23:15 |