|
|
|
 To label hard work as unfair is really a bitter assessment. - Koko Ed [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| To label hard work as unfair is really a bitter assessment. - Koko Ed [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
How much torque can the Dewalt Trannies take?
Has anyone driven the stock dewalt transmission components to failure, and if so, what did it take?
We're planning an offseason project that will interface three cims into the input of a single Dewalt. I know 2 cims has been done through a single Dewalt, but I think I'm probably riding the hairy edge of failure adding the third. Anyone with some info on what I should expect to fail first? Standard input per the NBD whitepaper. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How much of our wheel used for the shooter can be exposed? | waialua359 | Technical Discussion | 4 | 14-02-2006 13:27 |
| Servos - How much can they lift? | John JediMaster | Electrical | 23 | 31-01-2004 19:03 |
| how much is too much on the DRILL MOTORS? | archiver | 2001 | 11 | 23-06-2002 23:53 |
| How much can the window assembly lift? | archiver | 2000 | 9 | 23-06-2002 22:59 |
| How much code can an IFI controller handle? | Larry Barello | Programming | 7 | 10-02-2002 19:06 |
Threaded Mode