|
|
|
 Even if this is the Rumor Mill, there are behaviors that need to be adhered to. - meaubry [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Even if this is the Rumor Mill, there are behaviors that need to be adhered to. - meaubry [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
Help Programming a Quadrature Encoder
Hello, i am fairly new at programming, however i am capable or programming hybrid and tele-operated periods.... we recently added Quadrature Encoders and encoder disks. I need some help on programming them. Our robot leans to one side when driving full forward or reverse and we thought putting these on might fix that problem if we could program them by revolutions or something. Can anyone help us program these encoders or anywhere where we may be able to find a template program?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Quadrature shaft encoder source | billbo911 | Kit & Additional Hardware | 7 | 06-01-2008 19:52 |
| Encoder help | E_Unit | Electrical | 5 | 16-02-2007 11:02 |
| Turning a gear-tooth sensor into a quadrature output encoder | Jared Russell | Programming | 4 | 18-01-2006 22:19 |
| Encoder help | Windward | Programming | 21 | 14-01-2006 15:10 |
| shaft encoder help | stephenthe1 | Programming | 2 | 03-12-2004 16:09 |
Threaded Mode